Install The Plumbing - Kohler K-1018 Guia De Instalacion

Note: The control should be centered between the
studs. Adjustment of the control plumbing and
location may be needed if the wall is not plumb.
12-1/2"
(31.8 cm)
5-1/2"
(14 cm)
38-3/4"
7-1/4"
(98.4 cm)
(18.4 cm)
1. Construct the Stud Framing
IMPORTANT! Refer to the shower door installation instructions for any special framing considerations.
NOTE: Check the dimensions of the escutcheon included with the showerhead if applicable. If the
diameter of the escutcheon exceeds 3" (7.6 cm), the shower arm should be mounted above the shower wall
in an appropriate spot.
Study the roughing-in and framing diagrams.
Add any bridging or support needed if you are installing grab bars or towel bars. Refer to the
accessory manufacturer's instructions.
The plumbing may be installed on either wall. The supplied dimensions should be used on either
wall.
The showerhead may be installed in the shower wall or above the shower wall. Take into account
the height of the shower users when determining the installation location. The dimension provided
is for a shower wall installation only.
If the unit is installed against a masonry wall, use furring strips to secure the unit. The furring strip
configuration should match the stud configuration shown.

2. Install the Plumbing

Locate the drain according to the dimensions shown above. Measure and cut the drain hole opening
in the floor and install the rough drain lines.
Install the rough plumbing at the dimensions shown above. The rough plumbing should be in place
before the unit is installed.
Kohler Co.
38-3/4" (98.4 cm)
8"
16"
(20.3 cm)
(40.6 cm)
7-1/4" (18.4 cm)
4-1/2" D.
(11.4 cm)
This dimension is for mounting the showerhead in the
top of the shower wall. If you are mounting the
showerhead above the showerwall, disregard this
dimension and adjust the plumbing accordingly.
3
75-3/8"
(191.5 cm)
48"
(121.9 cm)
1024937-2-C