NORTH STATES 4934 Instrucciones página 7

If the mark on the upper locking housing is displaced to the left(10A) or right(10B) then:
Loosen the screw on the upper locking housing as shown in figure 10C adjust the gate until the marks
are aligned as shown in figure 10D.
If the upper locking housing is displaced upward 10F or downward 10G.
Loosen the screw on the door lower hinge.
Press the door panel and the lower door hinge towards each other as shown in figure 10H
until the two marks illustrated in 10D are aligned.
Retighten the screw on the door lower hinge.
10D
Alignment marks are now in proper position.
Retighten screw on upper locking housing.
Page 7