Publicidad
Idiomas disponibles
Idiomas disponibles
E N G L I S H
Safety instructions
When using power tools, always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and
personal injury. Read all of this manual
carefully before operating the tool. Save this
manual for future reference.
General
1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Do not expose the tool to rain. Do not use the
tool in damp or wet conditions. Keep the work
area well lit (250 - 300 Lux). Do not use the tool
where there is a risk of causing fire or
explosion, e.g. in the presence of flammable
liquids and gases.
3 Keep children away
Do not allow children, visitors or animals to
come near the work area or to touch the tool or
the mains cable.
4 Dress properly
Do not wear loose clothing or jewellery, as
these can be caught in moving parts. Wear
protective hair covering to keep long hair out of
the way. When working outdoors, preferably
wear suitable gloves and non-slip footwear.
5 Personal protection
Always use safety glasses. Use a face or dust
mask whenever the operations may produce
dust or flying particles. If these particles might
be considerably hot, also wear a heat-resistant
apron. Wear ear protection at all times.
6 Guard against electric shock
Prevent body contact with earthed surfaces
(e.g. pipes, radiators, cookers and refrigerators).
When using the tool under extreme conditions
(e.g. high humidity, when metal swarf is being
produced, etc.), electric safety can be improved
by inserting an isolating transformer or a (FI)
earth-leakage circuit-breaker.
7 Do not overreach
Keep proper footing and balance at all times.
8 Stay alert
Watch what you are doing. Use common
sense. Do not operate the tool when you are
tired.
14
All manuals and user guides at all-guides.com
9 Secure workpiece
10 Connect dust extraction equipment
11 Remove adjusting keys and wrenches
12 Extension cables
13 Use appropriate tool
14 Check for damaged parts
15 Unplug tool
16 Avoid unintentional starting
Use clamps or a vice to hold the workpiece. It
is safer and it frees both hands to operate the
tool.
If devices are provided for the connection of
dust extraction and collection facilities, ensure
that these are connected and properly used.
Always check that adjusting keys and
wrenches are removed from the tool before
operating the tool.
Before use, inspect the extension cable and
replace if damaged. When using the tool
outdoors, only use extension cables intended
for outdoor use and marked accordingly.
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended. Do not force the tool.
Warning! The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended in
this instruction manual may present a risk of
personal injury.
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation. Ensure
that the tool will operate properly and perform
its intended function. Do not use the tool if any
part is damaged or defective. Do not use the
tool if the switch does not turn it on and off.
Have any damaged or defective parts replaced
by an authorised BERNER repair agent. Never
attempt any repairs yourself.
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before
changing any parts of the tools, accessories or
attachments and before servicing.
Do not carry the tool with a finger on the switch.
Publicidad
