Technical Data - Electrolux EEG8000 Instrucciones De Uso

822 949 425_EEG8000.book Seite 32 Montag, 14. Juli 2008 7:56 19
g
0 Clean the motor base exterior
using a damp soft sponge with
mild detergent and wipe dry.
0 Wash the bean hopper and coffee
container in warm soapy water,
then rinse and dry.
Cleaning the burrs
If the coffee grinder is used fre-
quently (every day), the burrs need
to be cleaned every three weeks to
ensure best performance of the
coffee grinder. Regular cleaning
helps the burrs achieve consistent
grinding results, which is especially
important when grinding coffee for
espresso.
0 Ensure the coffee grinder is swit-
ched off and unplugged from the
power outlet. Remove the bean
hopper from the motor base (see
Fig. 7).
0 To remove the top burr turn the
grind adjustment collar in an anti-
clockwise direction until it stops
(see Fig. 8).
0 Press and hold down the
'UNLOCK' button at the rear of the
motor base and with the other
hand turn the grind adjustment
collar anti-clockwise until it stops
and the graphic line on the collar is
aligned with the line on the motor
base (see Fig. 9).
0 Lift out the top burr from the grind
adjustment collar using the handle
(see Fig. 10). Clean using the burr-
cleaning brush.
0 Lift the grind adjustment collar
away from the motor base.
0 Clean the bottom burr using the
burr-cleaning brush (see Fig. 11).
0 Once both burrs are cleaned,
return the grind adjustment collar
to its position in the motor base.
With the grind adjustment collar in
hand align the graphic line on the
collar with the line on the rear of
the motor base, press down (see
Fig. 12).
32
0 Replace the top burr back into
position in the grind adjustment
collar. Ensure the marker on the
top burr is aligned with the marker
inside the grind adjustment collar
and push firmly into place.
0 Turn grind adjustment collar clock-
wise to the desired grind setting.
Adjusting the burrs for wear
The conical burrs are made of tool
hardened steel for extra long life.
However after prolonged use the
burrs will require adjustment to
compensate for wear. A sign of this
is when the grinds are not as fine
as they used to be, check by rub-
bing some of the grinds between
two fingers or for espresso the
extraction will also show signs that
the grind needs adjusting. Please
contact the Customer Service
Centre.
Replacing the burrs
To inquire about having the burrs
replaced contact the Customer
Service Centre.

Technical Data

Mains voltage:
220 – 240 V / 50 – 60 Hz
Power consumption: 125 – 150 W
This appliance conforms with the
;
following EC Directives:
• Low Voltage Directive
2006/95/EC
• EMC Directive 89/336/EEC with
amendments 92/31/EEC and
93/68/EEC