Tabla de contenido
Publicidad
Identify pole sections.
2.
4
While maintaining alignment, bounce middle pole section (5) into top section (4)
3.
using a wood scrap as shown until the top pole no longer moves toward the pole
identification sticker on the middle pole.
IMPORTANT!:
Align dimple of top pole section (4)
into trough of middle pole section (5)
as shown.
TROUGH
5"
ID
STICKER
1-1/2"
DIMPLE
HOLE
5
Identification Sticker
5
4
13
6
CAUTION!
THE IDENTIFICATION STICKER IS
LOCATED 5" FROM THE END OF
THE POLE. WHEN PROPERLY
POUNDED TOGETHER, THE POLE
SECTIONS SHOULD HAVE A 3-1/2"
MINIMUM OVERLAP, LEAVING 1-
1/2" BETWEEN THE OVERLAPPING
POLE AND THE IDENTIFICATION
STICKER.
WOOD SCRAP
(NOT SUPPLIED)
07/04
P/N 21463608
Publicidad
Tabla de contenido
