Place Of Installation; Warning Signs - Vision SB-1900P El Manual Del Propietario

HANDLE THE POWER CORD WITH CARE
Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself. Pulling
the cord may damage it. If you do not intend to use your unit for any considerable length of time,
unplug the unit. Do not place furniture or other heavy objects on the cord, and try to avoid dropping
heavy objects on it. Do not tie a knot in the power cord. Not only could the cord be damaged, but a
short circuit could also be caused with a consequent fire hazard.

PLACE OF INSTALLATION

Avoid installing this product under the following conditions:
• Moist or humid places
• Places exposed to direct sunlight or close to heating equipment
• Extremely cold locations
• Places subject to excessive vibration or dust
• Poorly ventilated places
Do not expose this product to dripping or splashing. DO NOT PLACE OBJECTS FILLED WITH LIQUIDS
ON OR NEAR THIS PRODUCT!
MOVING THE UNIT
Before moving the unit, be sure to pull out the power cord from the AC outlet and disconnect the
interconnection cords with other units.

WARNING SIGNS

If you detect an abnormal smell or smoke, turn this product off immediately and unplug the power
cord. Contact your reseller or Vision.
PACKAGING
Save all packing material. It is essential for shipping in the event the unit ever needs repair.
IF ORIGINAL PACKAGING IS NOT USED TO RETURN THE UNIT TO THE SERVICE CENTRE, DAMAGE IN
TRANSIT WILL NOT BE COVERED BY WARRANTY.
WATTS
The most consistent standards for measuring watts are "Program Power" and "RMS" because these
measure average sustained levels.
Where loudspeakers have integrated amplifiers, then load (resistance, measured in ohms) is known so
the wattage rating is fixed.