Elite Cuisine EHP-001 Manual De Instrucciones página 5

HOW TO USE YOUR ELECTRIC HOT POT
WARNING:

This product generates steam and hot condensation during use and will remain hot
immediately after use; take precautions to prevent scalding and burns when
handling the product.

Do not use the product to cook raw meats, fish or poultry. This product is designed
for heating liquids/pre-cooked foods and is not intended for cooking raw foods.

Do not use this product to heat butter or oil.
CAUTION: Heating of foods such as spaghetti sauce, chili or other tomato-based products
is not recommended, as they could permanently stain the product.
1. Clean the product thoroughly before use, following the cleaning instructions in
the "Care and Maintenance" section.
2. Place the product on a flat, stable, heat and water-resistant surface.
3. Ensure the product is unplugged from the electrical outlet and the Control
Knob is at the "Low" position.
4. Add the contents to be heated into the product, ensuring that the products
stays level while adding contents.
WARNING: Do not fill above the "MAX" line or below the "MIN" line indicated
inside the product, and do not operate the product when it is empty.
5. Fully close the Lid and then plug the product into a standard electrical outlet.
NOTE: A slight odor may be emitted during the first few uses of the product;
this is normal.
6. The indicator light will turn on. Set the Control Knob to the desired position.
TIP: To heat milk and canned/pre-cooked foods (e.g. soups, sauces, canned
vegetables, etc.), set the Control Knob to a low setting and frequently stir
contents to prevent burning, sticking, and boiling over.
7. When contents are heated to the desired level, turn the Control Knob to the
"Low" position and then unplug the product.
WARNING: Do not allow the contents to evaporate as this may cause a fire
hazard. Always unplug the product from the electrical outlet when it is not in
use or will be left unattended
STEAMING:
1. Place the product on a flat, stable, heat and water-resistant surface.
2. Ensure the product is unplugged from the electrical outlet and the Control Knob is
at the "Low" position.
3. Place the Steamer Rack into the product.
4. Pour fresh room-temperature water into the product making sure the water does
not rise pass the Steamer Rack.
5. Place food to be steamed onto the Steamer Rack.
6. Fully close the Lid and then plug the product into a standard electrical outlet.
7. The indicator light will turn on. Set the Control Knob to the desired position.
8. When contents are steamed to the desired level, turn the Control Knob to the "Low"
position and then unplug the product.
Questions? We're here to help! Visit: www.maxi-matic.com for support on this product. 4