Stihl HL 100 Manual De Instrucciones página 24

English
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP - 0.
Starting
Press down the trigger lockout lever
N
and squeeze the throttle trigger
and hold them in that position.
N
Move the slide control to START
N
and hold it there.
Now release the throttle trigger,
N
slide control and trigger interlock in
that order. This is the starting
throttle position.
9
8
Set the choke knob (8):
N
For cold start to g
22
For warm start to e – also use this
position if the engine has been running
but is still cold.
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is already filled with fuel.
Put the unit on the ground: It must
N
rest securely on the engine support
and the gearbox.
On units with an adjustable cutter
N
bar and defined transport position:
Set the cutter bar to the straight (0°)
position.
Remove the blade scabbard. Check
N
that the cutting tool is not touching
the ground or any other obstacles. If
necessary, rest the gearbox on a
raised support (e.g. mound, brick or
something similar).
Make sure you have a firm footing.
N
Hold the unit with your left hand and
N
press it down firmly – your thumb
should be under the fan housing.
NOTICE
Do not stand or kneel on the drive tube
since it will otherwise be permanently
bent and damaged.
Pull the starter grip slowly with your
N
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Crank the engine until it begins to
N
fire. After no more than five
attempts, turn the choke knob to e.
Continue cranking.
N
As soon as the engine runs, blip the
N
throttle trigger so that the slide
control moves to the normal run
position F and the engine settles
down to idle speed.
Make sure the carburetor is correctly
adjusted. The cutting blades must not
move when the engine is idling.
Your machine is now ready for
operation.
At very low outside temperatures
As soon as the engine runs:
Blip the throttle trigger to disengage
N
the starting throttle position. The
slide control moves to the normal
run position F – and the engine
settles down to idle speed.
Open the throttle slightly and warm
N
up the engine for a brief period.
HL 100, HL 100 K