Using The Remote Control For Tv Operations - JVC TH-V70 Manual De Instrucciones

Using the remote control for TV operations

You can operate your TV using the remote control supplied with this system.
• Refer also to the instruction manuals supplied with your TV.
TV
TV AUDIO
button
AUX FM/AM DVD
VCR 1 VCR
DECODE
AUDIO ANGLE SUBTITLE
RETURN DIGEST ZOOM VFP
+
PROGRESSIVE
TOP MENU MENU ZOOM
–
SOUND
– +
CONTROL SUBWOOFER EFFECT
1 2 3
VCR
– +
CENTER TEST
4 5 6
TV
Number
– +
SLEEP REAR-L
7 8 9
buttons
– +
SETTING REAR-R
0 +10
10
TV CONTROL
TV RETURN FM MODE 100+
button
ON
SCREEN
AUDIO/
TV/VCR
Remote
CATV/DBS
ENTER
SURROUND
control mode
CHOICE
MODE
selector
CHANNEL
TV VOL CHANNEL VOLUME
+/– buttons
TV/VIDEO MUTING
1 ¡ TV/VIDEO
button
/REW PLAY FF/
DOWN TUNING UP
TV VOL +/–
REC STOP PAUSE
MEMORY STROBE
buttons
DIMMER
RM–STHV70U
DVD CINEMA SYSTEM
7 Setting the remote control signal for operating your TV.
• You can operate your TV without setting the remote control signal if your TV is a
JVC TV.
1 Slide the remote control mode selector to "AUDIO/TV/VCR."
2 Press and hold TV
• Keep it pressed until step 4 is finished.
3 Press TV CONTROL.
4 Press Number buttons (1-9, 0) to enter a manufacturer's code
(2 digit).
See the list below to find the codes.
• For a Hitachi TV, press 1, then 0.
• For a Toshiba TV, press 0, then 8.
5 Release TV .
6 Try to operate your TV by pressing TV
When your TV turns on or off, you have entered the correct code.
If there are more than one code listed for your brand of TV, try each one
until you enter the correct one.
Manufacturers' codes* for TV
Manufacturer Code Manufacturer
JVC 01
Hitachi 10
Magnavox 02
Mitsubishi 03
Panasonic 04,11
RCA 05
7 To operate your TV
You can use the following buttons for operating your TV:
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate TV, set it to "AUDIO/TV/VCR."
TV : Turns on and off your TV.
TV VOL +/–: Adjust the volume.
TV/VIDEO: Select the input mode (either TV or VIDEO).
• After pressing TV CONTROL, you can perform the following operations on the
TV.
CHANNEL +/–: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
.
Code
* Manufacturers' codes are
Samsung 12
subject to change without
Sanyo 13
notice. If they are changed,
this remote control cannot
Sharp 06
operate the equipment.
Sony 07
Toshiba 08
Zenith 09
AUDIO/
TV/VCR
CATV/DBS
.
20