Operation - Lacor MIX & GO 69386 Instrucciones De Uso Y Mantenimiento

1.- Plug the device into a suitable outlet. Be aware of the values defined in the specifications
section.
2.- Cut up the fruit or vegetables and put the pieces inside the glass pitcher (1) along with some
water or ice cubes.
NOTE:
Do not put bones or food with a tough skin in the device. Do not go past the
maximum line of the pitcher.
3.- Install the blade assembly (5) in the glass pitcher. Turn the blade assembly clock-wise until the
pitcher is complete closed (PHOTO 1).
4.- Assemble the glass pitcher onto the body (7) of the blender. Turn the pitcher clock-wise until
the arrows on the blade assembly and the body line up (PHOTO 2).
NOTE:
If the pitcher is not properly installed the motor will not start.
5.- Push the ON/OFF button (6) to start the device. The motor will run as long as the ON/OFF
button is pushed and it will stop when the button is no longer being pushed (PHOTO 3).
6.- If there is an obstruction while using the device stop pushing the ON/OFF button and, after the
device has completely stopped, remove the pitcher by turning it counter-clockwise. Unscrew
the blade assembly and remove any food with a spatula.
Re-assemble the pitcher to finish the process.
7.- To extend the useful life of the device, do not keep it running continuously for more than
1 minute. Take short breaks while chopping. If the body gets too hot, stop and unplug the
device for 2 minutes.
8.- After the process has finished, remove the pitcher by turning it counter-clockwise.
Unscrew the blade assembly and screw the lid (2) onto the pitcher (PHOTO 4).
9.- Put a straw (4) inthrough the top (3) of the glass pitcher lid (3) to consume the mixture
immediately (PHOTO 5).
10.- Remove the straw and close the top for storage (PHOTO 6).
1
4

OPERATION

2
3
5 6
35