Repair - Fiamma MARINA Manual De Instrucciones

ENGLISH
4. During the cleaning, the LEDs of both keys blink.
5. When the cleaning is over, the Leds stop to blink.
The machine automatically returns to normal functioning
mode.
6. Take out the filter holder.

You can run the cleaning program on several
groups at the same time.

In order to eliminate any unpleasant flavors after the cleaning, prepare a normal coffee.
6.2.2. CLEANING OF THE GRIDS AND TRAYS
Disconnect the machine from the electric mains supply before performing any kind of
cleaning!
Let the machine cool down before performing any kind of cleaning!
Remove the plastic grids of the cup warming area and the metal grids of the tray under the groups.
Remove the tray under the group.
Clean grids and tray with a humid cloth and a bit of specific detergent for coffee machines.
6.2.3. CLEANING OF THE DEPOSIT TANK
After extracting the tray under the groups, you have access to the machine's deposit tank. Clean the
tank and its drain with a brush. Make sure that the drain is not blocked by debris.
6.2.4. CLEANING OF THE MACHINE
Clean the machine's body with a humid soft cloth. Do not use abrasive or solvent detergents.

Regularly (at least every two weeks) clean the water purifier, following the instructions
supplied with it.

7. Repair

All repair and maintenance interventions must be carried out by qualified and authorized
persons.
If the power cable is damaged, it must be replaced only by specialized personnel and duly
authorized by the manufacturer.

Only use original spare parts.
The lower tray is not fixed to the machine's body. Take out the tray in order to get access to the motor,
to the main switch and the flowmeter.
Take off the upper tray in order to get access to the groups, the keyboards and the switches. In DI
models, taking off the upper tray will also give you access to the water tank. In order to take off the
upper tray, unfasten the screw in the center of the upper tray.
22
Espresso Coffee Machine Marina by fiamma – Operating Manual
4. Press the switch button above
the group in order to stop the group.
5. Repeat this operation until the
water that comes out of the group is
clear and shows no signs of detergent.
6. Take out the blind filter and put
a normal filter into the filter holder.
Insert the filter holder into the group.
7. Let the group run 2-3 times in
order to rinse it.