Home Decorators Collection HDI-4015-BK Guía De Uso Y Cuidado página 11

Troubleshooting (continued)
Problem
The light comes on for no
apparent reason.
The lights stay on
continuously.
The lights flash on and off.
The lights flash once then stay
off in manual mode.
Possible Cause
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "Sensitivity" setting is set too
high.
□
The "DUALBRITE" switch is in the
3 hour, 6 hour, or dusk-to-dawn
setting.
□
The outside temperature is much
warmer or cooler than a person's
body heat (summer or winter).
□
The light fixture is wired through a
dimmer or timer.
□
The motion sensor may be picking
up a heat source, such as an air
vent, dryer vent, or brightly painted,
heat-reflective surface.
□
The motion sensor is in manual
mode.
□
Light control is in D
□
The "Sensitivity" setting is set too
high.
□
The light fixture is wired through a
dimmer or timer.
□
The light fixture is on the same
circuit as a motor, transformer, or
fluorescent bulb.
□
Light control is in the TEST mode
and warming up.
□
Heat is being reflected from other
objects and may be turning the mo-
tion sensor on and off.
□
Nearby large, light-colored objects
reflecting light may trigger the shut-
off feature.
11
Solution
□
□
□
□
□
□
□
□
B mode.
®
ual rite
□
□
□
□
□
□
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Decrease the "Sensitivity"
setting.
Decrease the "Sensitivity"
setting.
The light fixture is operating
normally under these circum-
stances.
Decrease the "Sensitivity"
setting.
Do not use a dimmer or timer to
control the light fixture. Replace
the dimmer or timer with a
standard on/off wall switch.
Decrease the "Sensitivity"
setting.
Switch the motion sensor to
auto. See Using manual mode
on page 10.
Slide the D B switch to
®
ual rite
the OFF position.
Decrease the "Sensitivity"
setting.
Do not use a dimmer or timer to
control the light fixture. Replace
the dimmer or timer with a
standard on/off wall switch.
Install the light fixture on a cir-
cuit without motors, transform-
ers, or fluorescent bulbs.
Flashing is normal under these
conditions.
Decrease the "Sensitivity"
setting or reposition the motion
sensor.
Do not point other lights at the
sensor.