To Install The Auger Belt - Husqvarna ST 424 Manual Del Usuario

A
E
2. Remove the top 5/16'' bolts and the lower ¼''
bolts (D) from the 2 sides of the frame. Do not
discard the bolts.
3. Loosen but do not remove the lower 5/16'' bolts
(C) on the 2 sides of the frame.
4. Remove the auger belt (B) from the engine pulley
(A).
5. Tilt the rear section down. The front section tilts
forward at the same time. The bottom bolt is a
hinge between the front and rear sections.
6. Put a wooden block below the hinge point to set
the product in the tilted position.
7. Move the auger brake arm and remove the auger
belt (B) from around the auger brake arm.
To remove the auger belt (for ST 424T/
427T/430T only)
1. Remove the 5/16'' nut and the cable cover (E)
from the frame.
A
F
E
22
B
C
D
B
C
D
2. Remove the top 5/16'' bolts from the 2 sides of
the frame. Do not discard the bolts.
3. Remove the lower 5/16'' bolts (C) on the 2 sides
of the frame.
4. Remove the auger belt (B) from the engine pulley
(A).
5. Use the adjustment lever for the auger bucket to
tilt the rear section down. The front section tilts
forward at the same time. The bottom bolt is a
hinge between the front and rear sections.
6. Put a wooden block below the hinge point to set
the product in the tilted position.
7. Move the auger brake arm and remove the auger
belt (B) from around the auger brake arm.

To install the auger belt

1. Move the auger brake arm (G). Put the auger
belt around and in the groove of the auger pulley
(E).
A
G
F
CAUTION: Make sure that the belt is
not caught between the frame and
auger housing as you put the unit
together.
2. Remove the wooden block from below the
product.
3. Lift the handles to tilt the rear section up. The
front section tilts back and pivots to attach to the
rear section.
4. Make sure that the belt is put in the auger pulley
(E) groove correctly.
5. Install the 5/16'' bolts (C), and tighten (11-16
Nm).
6. For ST 424/427/430 only: Install the ¼'' bolts (D)
and tighten (5-8 Nm).
7. Install the auger belt (B) on the engine pulley (A).
Make sure that the belt is put correctly around
the idler pulley and installed correctly in the
engine pulley groove.
B
C
D
E
876 - 007 - 08.01.2020