To Set Up
NOTE: Use 16.4 oz disposable propane cylinders
only. Do not connect to bulk propane systems. The
LP-gas cylinder(s) used with catalytic heaters must be
constructed and marked in accordance with the
specifications for LP-gas cylinders of the U.S.
Department of Transportation or Transport Canada,
CAN/CSA B339 .
Features identified are Burner, Heater Valve,
Ignition Button, Support Leg, Cup Holder Adapter,
and AAA Battery. Propane tank is not included.
Cup
Holder
Heater
Adapter
Valve
CAUTION
• SERVICE SAFETY
• Keep all connections and fittings clean. Inspect
propane cylinder and heater propane connections
for damage before attaching.
• During set up, check all connections and fittings
for leaks using soapy water. Bubbles indicate a
4
leak. Never use a flame.
Unscrew ignitor button to
reveal battery compartment.
Install AAA battery
with positive (+)
outward.
Replace ignitor
button finger tight.
Ignition
Button
Burner
Support
Leg
Place CUP HOLDER
ADAPTER in cart as
AAA Battery
shown.
Place HEATER
ASSEMBLY in CUP
HOLDER ADAPTER.
To Light
Turn HEATER VALVE
to OFF.
• Propane is heavier than air and can accumulate in low places.
If you smell gas, leave the area immediately.
• Always attach or detach propane source outdoors; never while
heater is lighted, near flame, pilot lights, other ignition sources or
while heater is hot to touch.
• This heater is red hot during use and can ignite flammables too
close to the burner. Keep flammables at least 24 inches from the
Attach CYLINDER to
sides and 24 inches from the top of the heater. Keep gasoline
HEATER outdoors.
and other flammable liquids and vapors well away from heater.
•
Never leave heater unattended when hot or in use.
•
Keep out of reach of children.
DANGER
• EXPLOSION - FIRE HAZARD
WARNING
• BURN HAZARD