Selecting The Unit Of Length; Measuring Lengths - Parkside PLEM 20 A1 Instrucciones De Utilización Y De Seguridad

To Switch Measuring Reference point: Press and hold
MEAS button
from the top side of the product to its bottom side or vice
versa.

Selecting the unit of length

During the OFF mode
Press and hold the MEAS button
unit is displayed.
Now press once the MEAS button
(XXXXm, XX'XX", XXXXin, XXXXft).
To confirm the selection, press and hold the MEAS button
to save until the product turns on.
The following units of length are available:
m metre
in inch
ft foot/feet
' " feet/inches

Measuring lengths

Briefly press the MEAS button
beam.Once the laser is switched on, this is indicated on
the top left corner of the display by the icon
Note: If laser beam is already activated, the above
mentioned step can be skipped.
Now aim the laser at the target point. Briefly press the
MEAS button
the measured value will be shown on the bottom line of the
display and the laser beam will be turned off.
3 seconds to change measurement base
4
again. If the measurement is successful
4
until the number with
4
to choose the unit
4
again to activate the laser
4
4
.
7
GB/MT 41