Bonsaii S Serie Manual Del Usuario página 14

Operation:
Switch on the power button at the rear of the machine ("ON"). The "Standby" symbol lights up. The
equipment is now ready to use. Should the symbol not light up, then please refer to the section "General
Troubleshooting" on page 17 of this manual.
Shredding paper and credit cards
Place the paper in portrait orientation into the corresponding in feed unit. The paper will be
recognised by the sensors, and the cutter will begin to feed the paper through automatically. After
finishing shredding, you can press the
have minimal power consumption. Please insert credit cards in portrait orientation into the middle
of the feed unit.
Please press the
Please be aware of the maximum number of sheets of paper. Further information can be found on
the device, or in the table below entitled "Product Specification".
Overloading:
If you overload more paper in one go than the machine is able to handle, the overloading display
will turn to red,
reduce the number of sheets and try again.
automatically, then press the up arrow
reset to either normal or standby mode.
Shredding CDs/DVDs/credit cards
Insert CDs/DVDs/credit cards one by one into the designated in feed slot. Do not hold onto the
holes in the middle of the CD/DVD, as this could result in injury!
Manual in feed:
If a sheet of paper is too thin or too transparent for it to be recognised by the sensors, then please
press the "forward" button
excess sheets of paper to be shred.
Overheating:
It is possible that the engine may overheat if you exceed the maximum amount of time specified
for continuous operation. This is when the cutter will stop and the overheating light
red. The machine will then start to cool down whilst in standby mode, and can be used again when
the light stops flashing.
Removing excess paper:
Switch off the equipment, and disconnect the power supply. Remover the paper tray. Remove
any snippets of paper which have become stuck to the cutter. The blades are very sharp, so please
do take extra care!
Put the paper tray back into position, connect the power cable, and switch on the power. You can
button again to switch back from standby to operational mode.
and the cutter will stop immediately.
. You can also use the forward and backward buttons to allow any
button to switch from operation mode to standby and
Should this particular fault not be rectified
in order to remove any paper. The machine will then be
14
Should this happen, then please
will turn