General Electric AKV10 Manual Del Usuario página 10

Window installation instructions.
3
Remove the Air Conditioner From the Case
Remove and discard the 2 shipping screws
A
from the bottom rear of the case.
Pull to unlatch the lower corners of the inlet
B
grille and lift it up and off.
Using the tab, pull up slightly on the filter
C
to release it and pull it down to remove.
Remove the two grille frame screws.
D
Grasp the lower corners of the grille frame
E
while pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the
bottom edge toward
you more than 3 " or
you may damage the
tabs of the grille.
10
On some models, you must also disconnect
F
the control connectors before the grille frame
can be removed. Press the locking tabs in
while pulling on the other side to release.
Remove the locking screw and locking bracket
G
from the lower front of the unit.
Remove the screw securing the ground wire
H
to the right side face of the unit.
Grille frame
Slide the air conditioner from the case by
I
screws
gripping the base pan handle and pulling
forward while bracing the case.
Press in
Pull
Press in
Ground wire
Screw