General Electric AKV10 Manual Del Usuario página 14

Window installation instructions.
8
Install the Case in the Window
Carefully position the case in the window
A
until the bottom mounting rail drops into the
channels in the supports. Center the case and
lower the window behind the top mounting
rail. The case should be slightly tilted to the
outside. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Attach the bottom of the case to the support
B
rail with four Type C screws, two on each side,
with a flat washer under the head of each screw.
9
Secure the Case in the Window and Install the Foam Top Window Gasket
Drill a 1/8" pilot hole and attach the top
A
mounting rail to the sash with a Type B screw.
14
Type B screw
Top mounting rail
Extend the left and right accordion panels
C
to the vertical window sashes and attach the
top corners with 2 Type B screws. Use an
accordion panel clamp on each lower corner
to trap the panels. Attach them to the stool
using 2 Type B screws.
Top mounting rail
Type B
screw
Panel clamp and
Type B screw
NOTE: Seal any openings around the case or accordion
panels with sealer or foam gaskets.
Cut the foam top window gasket to the
B
window width.
Stuff the foam between the glass and the
C
window to prevent air and insects from
getting into the room.
Attach the window locking bracket with
D
2 Type B screws.
Type B
screw
Panel clamp and
Type B screw