Troubleshooting - Hoover IRONspeed Manual Del Usuario

Troubleshooting

14 -
GB
Ironspeeed_SR__1-15_union_pprod3.indd 14
Problem
The appliance does There is a connection
not become hot problem
The appliance is not
switched on
The soleplate temperature
is too low
The appliance does The appliance is not
not produce steam switched on
The boiler has not yet
heated up
The water tank may be
empty
You are not pressing the
steam trigger
The soleplate temperature
is set to the maximum
Steam escapes from The calc removal valve is
the calc removal cap not tightened enough
when ironing
The anti-scale valve is
damaged
The empty water tank There is no more water in
LED is on the tank
The soleplates There should be chemical
becomes dirty or or additives in the water
brown used for ironing
The linen is still dirty
Water stripes appear Your ironing board cover is
on the textile saturated in water
Some scale deposit Your boiler has not been
appears on the rinsed for a while
soleplate
Cause
Check the mains cord, the
plug and the wall socket
Press on the on/off switch
Set a higher temperature of
the soleplate
Press on the on/off switch
Wait a few moments until
the steam ready LED is off
Refill the water tank
Press the steam trigger
It works but steam is not
visible as very hot and dry
Switch off the appliance
and let it cool down.
Remove the calc removal
cap and tighten the valve
correctly
Contact your after sales
service
Refill the water tank with
water
Never use any chemical or
additives in the water.
Contact your after sales
service if the linen is still
dirty
Clean the soleplate with a
non-metallic sponge
Change the cover or use a
mesh ironing board
Follow the indications in the
appropriate chapter
Solution
11-12-2009 9:59:58
15 15