Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Checking the battery condition
NOTE: Fig. A only applies for the battery
pack with battery indicator light.
Charging the battery pack
NOTE:
•
The batteries are shipped un-
charged. Each battery must be fully
charged before the first use.
•
Always fully charge the two batteries
at same time. More details can be
found in charger's manual.
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices.
Never insert or allow metallic
objects into your charger or battery
pack connections because of an
electrical failure and hazard will
occur.
Installing and Removing the battery pack
NOTE:
This machine will only run when
•
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
•
When you use two batteries with
different power,the machine will
only run to the level of the lowest
charged battery
Battery indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the machine may still
be capable to work. Continuing
to operate your machine with the
battery in this discharged condition
may reduce the life and performance
of your battery.
When no light is illuminated, at least
one battery is not fully installed or
battery may be defective, please
double check the batteries are fully
seated into position.
OPERATION
Blow mode
Assembling the Blower Tube and fan
housing cover
Cordless Blower/Vac/Mulcher
On/Off Switch
WARNING! The tool runs for a
FIGURE
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool
down.
See Fig. A
Using the Blower
USER TIPS
- Hold the blow tube approximately 8"
above the ground when operating the
tool.
- Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
Caution!
Do not blow hard objects such
See Fig. B
as nails, bolts, or rocks.
Adjusting the blowing speed
NOTE:the speed your tool keeps each
time you turn it on is the speed when
you turned it off last time. If necessary,
please readjust the speed.
Vacuum mode
Disassembling the blower tube and fan
housing cover
Assembling the vacuum Tube and wheel
See Fig.C
Assembling he Leaf Collection Bag
On/Off Switch
WARNING! The tool runs for a
few seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool
down.
Using the Vacuum
NOTE:It is recommended to use high
speed for best vacuum performance.
Disassembling the vacuum Tube and the
See Fig. D
Leaf Collection Bag
Emptying the Leaf Collection Bag
Removing Clogged Debris from the
Impeller(no tool included)
NOTE: Ensure to remove the
batteries before attempting to clear
any debris.
BATTERY STATUS (See Fig. D)
•
Before starting or after use, press the button beside
See Fig.
the power indicator light on the machine to check
E1,E2,E3
the battery capacity.
See Fig. F
See Fig.G
See Fig.H
See Fig. I1,I2
See Fig.
15
J1,J2
See Fig. J3
See Fig.F
See Fig. K
See Fig.L1,L2
See Fig.
M1,M2
See Fig. N
EN
Publicidad
