Electric Connection - D'KOCINA La Cottura Manual De Uso

INSTRUCTIONS FOR USE
1.3

Electric connection

The appliance must be connected electrically only by qualified person-
nel aware of the current regulations on installation in force.
The appliance is ready for operating in alternating current, at the voltage
shown on the "characteristic data" plate shown at the end of the booklet
and on the product (also see any connection diagram on the product).
In case of direct mains connection, an omnipolar switch must be pla-
ced between the appliance and the mains, with a contact opening gap
which enables total disconnection in overvoltage category III conditions,
in compliance with installation regulations. The yellow/green earth wire
must not be interrupted by this switch.
The power supply cable must be H05RR-F or higher category (list of
sections in the following table); and must be positioned in such a way
that at no point can a temperature 50°C above ambient temperature be
reached.
MAX POWER
up to 16 A
up to 25 A
up to 32 A
Before making the connection, check that the power circuit has an effec-
tive earthing that meets regulations in force and that the socket or the
omnipolar switch is easily reached when the appliance is installed.
The earth cable (yellow/green) connected to the product's terminal must
be longer than the others.
The manufacturer declines all liability in the event that the regula-
tions in force are not respected.
24 / GB
CABLE SECTION mm2
1,5 mm2
2,5 mm2
4 mm2