Tuner; Error Messages - Pioneer XV-DV333 Manual De Instrucciones

10 Additional information
Problem
CD-ROM disc is not
recognized by the
system.
Files don't show up in
the Disc Navigator/
Photo Browser.
Can't play WMA files.

Tuner

Problem
Considerable noise in
radio broadcasts.
Auto tuning does not
pick up some stations.

Error Messages

Message
Key Lock
RMode On
PhonesIn
96k
Muting
Exit
Noisy!
Err MIC!
Err SP!
46
En
Remedy
• Make sure that the CD-ROM was recorded using the ISO 9660 disc format.
See Disc compatibility table on page 39 for other disc compatibility
information.
• The files on the disc must be named with the correct file extension: .mp3
for MP3 files; .wma for WMA files; .jpg for JPEG files (upper or lower-case is
OK). See Disc compatibility table on page 39 for more on this.
• The files were recorded using DRM (digital rights management). This is not
a malfunction.
Remedy
• Connect the AM antenna (refer to the Setup Guide) and adjust the direction
and position for best reception. You may also connect an additional internal
or external AM antenna (refer to Connecting external antennas on page 30).
• Fully extend the FM wire antenna, position for best reception, and secure to
a wall. You may also connect an outdoor FM antenna (see Connecting external
antennas on page 30).
• Turn off other equipment that may be causing the noise or move it further
away.
• The tuning interval is incorrect for your country or region (see Frequency
step setting on page 37).
• The radio signal is weak. Auto tuning will only detect radio stations with a
good signal. For more sensitive tuning, connect an outdoor antenna.
Description
• The child lock feature is active. See Key lock setting on page 37.
• An operation is prohibited because the Recording Mode is on (see
Recording mode on page 30).
• An operation is prohibited because headphones are connected.
• An operation is prohibited because the source is digital 88.2 or 96kHz PCM.
• An operation is prohibited because the sound is muted (press MUTE).
• Appears when a menu is automatically exited after a set period of inactivity.
• Appears when the ambient noise level is too high during MCACC setup.
There is a problem with your mic connection
•
• There is a problem with one of the speaker connections during MCACC
setup.
during MCACC setup.