Hamilton Beach FlexBrew 49949 Manual Del Usuario página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
Coffee Maker will not brew/coffee not dispensing.
The piercing needle may be clogged. Always remove Gray
Removable Needle Holder. Clean piercing needle in Lid of Coffee
Maker as shown on page 8.
Mineral deposits have formed. Clean Coffee Maker following
directions in Care and Cleaning section.
Coffee tastes bad.
Too much water was added or too much or too little ground coffee
was added. Change amount of water to coffee grounds or use less
water with coffee pods.
Poor coffee quality and freshness.
Poor water quality (use filtered or bottled water).
Coffee sediment in cup.
Try a more coarsely ground coffee or add a #1 paper cone coffee filter to
Brew Basket. Make sure hinged Lid is closed on Removable Brew Basket.
Water on counter under unit.
Overfilled Water Reservoir. Do not add more than 14 ounces (414 ml)
of water. Some mugs/cups do not pour cleanly and can dribble water
down side of cup and onto counter.
Coffee overflows from Brew Basket.
Use Removable Brew Basket with Lid for ground coffee.
Use a lesser amount of ground coffee. 3 tablespoons (44 ml) is
maximum amount of grounds to brew.
When using whole bean coffee, a standard automatic drip coffee
grind will yield best results. Be careful not to overgrind, since very
finely ground coffee can cause overflow.
Black seal around needle in Removable Needle Holder is missing.
Carefully place seal around needle and push until in place.
Coffee overflows from mug or travel mug.
To prevent coffee overflowing from a mug/travel mug, use same
mug/travel mug to brew into that was used to fill Water Reservoir.
Do not add more than 14 ounces (414 ml) of water. There may also
be additional water in system that is causing overflow. Remove
Brew Basket or Single-Serve Pod Holder. Press and hold BREW REG
or BREW BOLD button to remove any remaining water.
Coffee single-serve pod bursts.
There is variability in single-serve pod manufacturing process, which
causes some types of single-serve pods to be weaker at seams; so
foil seal fails. Try a different brand.
You have soft water or a water softening system. Use bottled water
for better-tasting coffee and to help prevent a clogged filter.
Brew Indicator Light flashes:
2 times: Coffee Maker needs to be cleaned. See page 8.
3 times: Coffee Maker Lid is not closed properly. Push Lid down to
lock into place.
7 times: Coffee Maker needs to be cleaned. See page 8.
8 times: Needle is clogged. Always remove Gray Removable Needle
Holder and follow "Clogged Needle" on page 8.
9 times: Not enough water. Add water to Water Reservoir.
Frother red and blue lights flashing.
Allow Frother to cool.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

A143

Tabla de contenido