Assembly - Husky 8111011 Guía De Uso Y Cuidado

Assembly

WARNING: To reduce the risk of fire or explosion, do not operate this vacuum in areas with flammable gases, vapors or explosive
dust in the air. Flammable gases or vapors include but are not limited to: lighter fluid, solvent-type cleaners, oil-based paints, gasoline,
alcohol or aerosol sprays. Explosive dusts include but are not limited to: coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not use this vacuum as a sprayer for any flammable or
combustible liquid. To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic materials.
WARNING: The operation of any utility vacuum can result in foreign objects being blown into the eyes, which can result in severe eye
damage. Always wear safety eyewear complying with ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION: To reduce risk of hearing damage, wear ear
protectors when using the vacuum for extended hours or
when using it in a noisy area. This 37.9 Liter / 10 Gal wet/dry
vacuum is assembled at the factory and ready for use when
you remove it from the carton. The unit is ready for dry
vacuuming or blowing. After you plug the power cord into the
wall receptacle, turn the unit "ON" by pushing the switch from
position "O" to position "I" as shown in Figure A. The "O" is
the "OFF" position and the "I" is the "ON" position.
O = OFF
I = ON
NOTE : The wire may be stored by wrapping it around the
two hooks on the handle as shown in Figure A.
WHEEL DOLLY & STORAGE BOX ASSEMBLY
□
Take out all the accessories out of the tank and place the
tank upside down.
□
Install the axle (J) through one rear wheel (A), attach with
the washer (I) then fix and bend the pin (I) at the end of the
axle (J). (Fig. 1)
□
Place the axle (J) through the stroage, and then intall
another wheel (A) on the other end of the axle (J). (Fig. 2)
Figure A
□
Install the axle (J) through the storage and rear wheels (A).
Then attach with the washers (I) on each side the wheel (A),
put the pin (I) through the hole and bend it at the end of
the axle (J) to fix the wheels (A). (Fig. 3 )
J
A
I
I
Fig. 1
Fig. 3
TRANSPORT HANDLE ASSEMBLY
□
Attach side tank handles (F) to the tank with the screws (P)
provided. (Fig. 4)
□
Insert the transport handle (G) into the side tank handles (F).
(Fig. 5)
Rubber washer
Metal washer
P
Fig. 4
5
l P a e e s o c t n c a
A
Fig. 2
G
F
Fig. 5
H U S Y K
1 t 8 - 8 8 H - D H - U S KY for further assistance.
J
F
O T O S L C . O M