Maintenance; Limitations On Use - Blatchford 189626 Instrucciones De Uso

5 Maintenance

Visually check the device regularly.
Report any changes in performance of this device to the practitioner/service provider e.g.
unusual noises, increased stiffness, restricted/excessive movement or significant wear.
Inform the practitioner/service provider of any changes in body weight and/or activity level.
Cleaning
Use a damp cloth and mild soap to clean outside surfaces. DO NOT use aggressive cleansers.
The remaining instructions in this section are for practitioner use only.
This maintenance must be carried out only by competent personnel (practitioner or suitable
trained technician).
The following routine maintenance is to be carried out at least annually:
• Check the socket cap screw for tightness, see Construction section. If loose, remove and
clean, then apply Loctite and tighten to the correct torque setting
• Check for defects that could affect proper function
Ensure the user has read and understood all safety and user-level maintenance information.
Advise the user that a regular visual check of the device is recommended and signs of wear that
may affect function should be reported to their service provider (e.g. significant wear).
If this device is used for extreme activity, the maintenance level and interval should be reviewed
and if required advice and technical support sought to plan a new maintenance schedule
dependent upon the frequency and nature of the activity. This should be determined by a local
risk assessment carried out by a suitably qualified individual.

6 Limitations on Use

Intended Life
A local risk assessment should be carried out based upon activity and usage.
Lifting Loads
User weight and activity is governed by the stated limits.
Load carrying by the user should be based on a local risk assessment.
Environment
This device is waterproof to a maximum depth of 1 meter. Thoroughly rinse with fresh water
after use in abrasive environments such as those that may contain sand or grit, for example, to
prevent wear or damage to moving parts. Thoroughly rinse with fresh water after use in salt or
chlorinated water.
Exclusively for use between -15 °C and 50 °C
(5 °F to 122 °F).
6
938395PK1/1-0421