HoMedics enviraScape BUDDHA Manual De Instrucciones Y Garantía página 6

1. Unpack the product from package carefully. Keep packaging material for safe
storage.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch
located at the front of the pump. The speed is indicated by a plus(+) and minus(-)
sign. To increase the speed, move the switch slowly in the direction of the plus sign.
You will hear a click as the switch moves to each speed level. At its highest speed
level, the switch will cease to move any further. To decrease the pump speed, move
the switch toward the minus sign. Similarly, at its lowest speed, the switch will cease
to move any further.
Note: It is recommended the pump be set at its highest speed during assembly
and later adjusted to a lower setting if desired. Be sure to unplug the pump before
adjusting the speed setting.
3. Insert the tube (located on the bottom of fountain top) onto the pump.
4. Fill base with tap water to 1" from top. We recommend using distilled water to
prevent mineral build up.
5. Set the Buddha fountain top onto the base by notch so it sits level.
6. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this
time.
7. Set the fountain on a level, waterproof surface.
8. Plug the cord into 120V household outlet. The fountain is controlled by the switch
located on the power cord. If pump doesn't operate, rotate in-line switch once to
turn "on" and once more to turn "off".
Note: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip
Loop'. This will prevent water from running down the cord into the electrical outlet.
5