Technical Data; General Warnings - Rupes AR11S Traducción De Manual De Instrucciones Original

TECHNICAL DATA

INSULATION CLASS
ABSORBED POWER W
ELECTRONIC OVERLOAD PROTECTION
ELECTRONIC SPEED CONTROL
n NOMINAL RPM /min
Ø COLLET DIAMETER mm
Ø MAXIMUM WHEEL DIAMETER mm
WEIGHT Kg according to EPTA-Procedure 01/2003
* On request, collect reduction from Ø 6 to Ø 3 mm.
** On request, collect with Ø 3 mm or Ø 6,35 mm.
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and frequencies of different power values may vary.
Refer to the label technical specifications to the nominal values of the tool.

GENERAL WARNINGS

All instructions concerning safety and the prevention of industrial accidents can be
found in file SAFETY INSTRUCTIONS, that forms integral part of this
documentation. This INSTRUCTION MANUAL only contains additional information
that specifically explain how to use the machine.
SPECIFIC USE
The straight grinder is suitable for grinding materials such as wood, metals, pla-
stics or similar, especially in places that are difficult to access.
Use the product only for its intended use. Observe the manufacturer's indications
and the permitted accessories.
GENERAL SAFETY WARNINGS FOR CORRECTION AND ABRASIVE CUTTING
OPERATIONS
This tool is designed to be used as grinder. Refer to all the safety warnings,
instructions, illustrations and specifications supplied with the tool. Failure to follow
all the instructions provided below may result in electric shocks, fires and/or serious
injuries.
Theuse of this tool for smoothing, metal brushing and polishing operations is not
recommended. Its use for applications other than those for which it has been designed
may lead to hazardous situations and cause injuries to people.
Do not use accessories that are not specifically designed for the intended use of
the tool or that have not been recommended by the manufacturer. The fact that an
TYPE AR11S AR52ES
/ II / II
700 600
NO YES
NO YES
9.000 3.000÷7.000
6* 6*
45 45
1,5 1,5
accessory can be fixed to the tool does not imply that it can be used safely.
The rated speed of accessories must be at least equivalent to the maximum speed
of the tool. If operated at a greater speed than the rated one, accessories may break and
cause the ejection of chips.
The external diameter and thickness of accessories must be appropriate to
guarantee the protection and safety of the tool. Accessories with incorrect dimensions
cannot be adequately protected or controlled.
Abrasive discs, flanges, sanding pads or other tool holders and
accessories must properly fit the wheel holder spindle of the electric tool
supplied. Tool holders and accessories that do not fit perfectly with the wheel
holder spindle of the electric tool do not rotate evenly, vibrate excessively and
may cause loss of control.
The discs, sanding cylinders, cutting tools or other accessories fitted on
the spindle must be fully inserted into the clamping collet. If the spindle is
not sufficiently tightened and/or the protrusion of the disc is excessive, there is
a risk that the mounted disc can come loose and be launched at high speeds.
Never use a damaged accessory. Before every use, check the tool holders
and accessories and ensure that the abrasive wheels have no chips and
cracks, that the sanding pad is not subject to cracks, or excessive wear
and that the metal brushes do not have loose or cracked wires. If the tool
or accessory used were to slip from your hand and fall, ensure that it has
not suffered any damage or use an undamaged accessory. After
inspecting and installing the tool holder or accessory, operate the electric
AR38S AR38ES
/ II / II
800 800
NO YES
NO YES
30.000 18.000÷30.000
6** 6**
25 25
1,5 1,5
9