Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ADDITIONAL INFORMATION FOR PROGRAMMING THE MRL DCP
SMS COMMANDS
+
All MRL DCP parameters can be remotely configured via an SMS sent to the SIM card's number
+
Each SMS message should begin with 'Pin1234' which is the access code to read or make any changes to the
configuration of the MRL DCP
+
You can modify or check several parameters in each SMS by separating them with commas ","
To send parameter information:
Pin1234, Pxxx then value to set, (send)
To read parameter information:
Pin1234, Pxxx? (send)
Note: Use a question mark '?' when you are reading parameters.
Examples:
1.
To program telephone number 1 in the MRL DCP when connected to a DAU
E.g. Pin1234, P031 0123456789 (send, text message will come back with P031=0123456789)
2.
To retrieve telephone number 1 in the MRL DCP when connected to a DAU
E.g. Pin1234, P031? (send, text message will come back with P031= or with the programmed number)
Note: To reset your unit to default settings the following parameters are important.
CMD
P005
P020
P064
P031
P032
P033
P034
P035
P008
P085
P091
P003
Important Note: The default PIN code for DCP is 1234.
Description
CCID- Unique Identifier of the Sim Card
MRL DCP Background Call Mode
P020=00 -> Memtel Protocol
P020=06 -> CAN Protocol
P020=21 -> P100 Protocol
Background Call Periodicity (in Minutes)
Alarm Number 1
Alarm Number 2
Alarm Number 3
Alarm Number 4
Background Number (not used with DAU)
Enable Guidance Message *
Language
Super settings set up
MRL DCP information (software version, type of DCP)
Default value
(19 digits)
21 (Autodiallers need to make
Background calls in P100
Protocol)
4320 (3 days)
(Blank – Insert your alarm
number here)
(Blank)
(Blank)
(Blank)
3308084431 (must match
Background Number in
Autodialler, without prefixes)
0 (disabled)
4 (English)
000
As per package
10
Publicidad
Tabla de contenido
