Pre-Installation Requirements; Technical Information; Important - Glass 1989 SHOWERWAVE Manual De Instalación - Uso - Mantenimiento

of the appliance by a person responsible for their safety.
• WARNING: children may use the product unsupervised only
when its operation has been clearly explained to them and
they are able to use it safely while recognising the dangers
of misuse.
All measurements are in mm.

PRE-INSTALLATION REQUIREMENTS

To prevent damaging the mixer parts, place a filter upstream of
the mixer.

TECHNICAL INFORMATION:

• Minimum flow pressure:
150 kPa (1,5 bar)
• Operating pressure:
350 kPa (max 3,5 bar)
• Recommended operating pressure:
250 kPa (2,5 bar)
• Hot water temperature:
max 60°C
The product's supporting structure is metallic. An efficient
ground system is therefore required, with sensitivity meeting
the relevant standards.
GROUNDWIRE.
The ground wire must be connected and fixed permanently
to the electrical system.
EQUIPOTENTIAL CONNECTION.
The equipment must be connected to the equipotential
system of the room and duly fastened to its terminal to be
found in the product.
The following accessories
manufacturer) are required for installation:
a) Fittings to connect the mixer to the domestic water mains
(connection to mixer via ½" fittings).
ROUTINE AND
SPECIAL MAINTENANCE
Use water up to a maximum of 60°C to maintain the shine of the
product over the years.
Use a soft sponge dampened with water and non-abrasive
neutral liquid detergents
for cleaning.
After cleaning, rinse thoroughly with plenty of water to
remove all traces of detergent and dry with a soft cloth.
Avoid:
– cleaning materials which contain hydrochloric acid, formic acid,
bleach or acetic acid, as they can cause considerable damage.
– synthetic fibre cloths, scouring pads, metal pads, abrasive
detergents, alcohol, acids for domestic use, acetone or other
solvents which damage the surface.
–the build-up of limescale by cleaning regularly.

IMPORTANT:

Residues of toiletries such as liquid soaps, shampoos and shower
gels, hair dyes, perfumes, aftershave and nail varnish can also
cause damage.
Rinse thoroughly with plenty of water to remove all traces
of detergent.
Limescale can be removed from water jet nozzles simply by
rubbing.
(not supplied by the
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All hydraulic connection checkup must be performed by a
hydraulic installation technician.
If the water is slow to drain away, check that the drain is not
blocked.
If the product does not dispense water, check that:
- There is water in the main pipe.
- The diverter is correctly set.
- There are no impurity into the pipes that prevent normal
water flow.
If the above operations do not solve the problem, contact your
nearest service centre or the company.
9
EN