Product Maintenance - Fellowes Powershred 53C Manual Del Usario

Ocultar thumbs Ver también para Powershred 53C:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 6
BASIC SHREDDING OPERATION
Continuous operation:
Up to 3 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3 minutes will trigger a
30-minute cool down period.
TROUBLESHOOTING
PAPER JAM
1
2
Set to Reverse (R)
Alternate slowly back and forth
for 2-3 seconds

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Set to Off ( )
* Apply oil
across entry
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date of
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
PAPER OR CD/CARD
1
1
2
Plug in and put
Set to Auto-On (I)
disconnect power
switch in ON (I) position
4
3
Set to Off ( )
and unplug
3
Set to Reverse (R)
2-3 seconds
3
4
or
paper entry and release
entry and release
5
6
Gently pull uncut
Set to Auto-On
paper from paper
(I) and resume
entry. Plug in
shredding
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
service under this warranty, please contact us or your dealer.
5
When finished shredding
)
Shredder doesn't start:
Make sure head is on basket correctly
Wait 30 minutes for motor to cool down
Remove and empty basket
3

Publicidad

Tabla de contenido
loading

Tabla de contenido