CyberPower Systems OR1000ERM1U Manual Del Usuario página 4

USB Port to PC
9.
The USB port allow communication from the UPS to the computer. The UPS communicates its
status to the PowerPanel
Serial Port to PC
10.
The port allows connection and communications from the DB-9 serial on the computer to the
UPS unit.
Circuit Breaker
11.
Located on the side of the UPS, the circuit breaker serves to provide overload and fault
protection.
AC Input
12.
Connect the AC Power cord to a properly wired and grounded outlet.
1. Your new UPS may be used immediately upon receipt. However, recharging the battery
for at least 8 hours is recommended to ensure that the battery's maximum charge
capacity is achieved. Charge loss may occur during shipping and storage. To recharge
the battery, simply leave the unit plugged into an AC outlet. The unit will charge in both
the on and off position.
2. If you will use the software, connect the USB cable to the USB port on the UPS.
3. With the UPS unit off and unplugged, connect the computer, monitor, and any
externally powered data storage device (Zip drive, Jazz drive, Tape drive, etc. into the
battery power supplied outlets. DO NOT plug a laser printer, copier, space heater,
vacuum, paper shredder or other large electrical device into the UPS. The power
demands of these devices will overload and possibly damage the unit.
4. To protect a fax, telephone, modem line or network cable, connect a telephone cable or
network cable from the wall jack outlet to the IN jack of the UPS. Then connect a
telephone cable or network cable from the OUT jack on the UPS to the modem,
computer, telephone, fax machine, or network device.
5. Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the
wall branch outlet is protected by a fuse or circuit breaker and does not service
equipment with large electrical demands (e.g. air conditioner, refrigerator, copier, etc.
Avoid using extension cords. If used, the extension cord must be grounded and rated
for 15 amps.
6. Depress the power switch to turn the unit on. The power on indicator light will
illuminate and the unit will "beep" once.
7. If an overload is detected, an audible alarm will sound and the unit will emit one long
beep. To correct this, turn the UPS off and unplug at least one piece of equipment from
the battery power supplied outlets. Wait 10 seconds. Make sure the circuit breaker is
depressed and then turn the UPS on.
8. Your UPS is equipped with an auto-charge feature. When the UPS is plugged into an
AC outlet, the battery will automatically recharge.
9. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all
times. 10.To store your UPS for an extended period, cover it and store with the
battery fully charged. Recharge the battery every three months to ensure battery life.
3
®
Business software when connected with a USB port.
Hardware Installation Guide