Hardware Installation - MICRADIGITAL 802.11g Manual Del Usuario

Hardware Installation

Warnings: Network cards are sensitive to static electricity. To protect the
card, always touch the metal chassis of your notebook or the ground before
handling the card.
1. Turn on your notebook.
2. Find an available Type II or Type III PCMCIA slot in your notebook.
3. With the PC Card's 68-pin connector facing the PCMCIA slot, label side up,
slide the card completely into the slot as shown below.
Note: The PCMCIA slot allows you to "hot swap" PC Cards any time.
4. Install the appropriate driver into your system. Drivers can be found on the
driver CD that comes with the package. See the following section for
instructions.
4