Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING OR REPLACING THE CUTTER
The machine is equipped with a mechanism which allows for the cutter to be quickly replaced without the need for
tools (fig.6). In order to install or replace a cutter, push the support (fig.7) upwards and extract the worn cutter, if
already present upon the support (fig.8). While keeping the support pressed upwards, insert the new cutter then
release the support. A spring action mechanism will automatically reposition the support in its original position,
thereby locking the new cutter in place. If replacing a worn cutter during work activities, it may be necessary to clean
any residual grass and/or soil off of the support. Make sure that no debris enters the quick attachment mechanism
while installing the new cutter. It is nevertheless recommended to clean and lubricate the quick attachment
mechanism frequently (see also "CLEANING THE CUTTER SUPPORT").
ADJUSTING THE CABLE LAYING DEPTH
In order to adjust the machine's cable laying depth, use the knob on the back of the pin (fig.9,
no.1). Loosen the knob by a few turns counter-clockwise and raise or lower the support for the
two rear wheels (fig.9, no.3), using the depth of the graduated bar beside the support (fig.9,
no.2) as a reference. Once the desired depth has been obtained, turn the knob (fig.9, no.1)
clockwise until it has been properly tightened. The numbers on the graduated bar correspond
to centimetres in depth, and range from 1 to 6.
ADJUSTING THE SPEED
In order to adjust the cable layer's speed, use the accelerator's throttle (fig.1, no.3) to increase or decrease the
motor's rpm value. NEVER adjust the speed by making the clutch disks for the transmission's gearbox slip. This can
cause serious damage to the transmission's mechanical parts. The advancement lever must ALWAYS be pulled to its
maximum extent, or rather until it makes contact with the handlebar unit.
ADJUSTING THE HEIGHT OF THE HANDLEBAR UNIT
The machine provides for five different handlebar heights. In order to adjust the height,
loosen the handle at the back of the handlebar unit (fig.10, no.2) by turning it counter-
clockwise until the knob can be extracted (fig.10, no.1). Select the desired height and then
reinsert the knob, turning it clockwise until the handlebar unit has been properly
tightened.
Fig.3
Fig.6
1- Removable plate
2- Knob
Fig.4
Fig.7
15
Fig.9
Fig.10
Fig.5
Fig.8
Publicidad
Tabla de contenido
