GNB SP Serie Instrucciones De Utilizacion página 4

Operating Instructions and Safety Precautions
Safety
Only a trained person should operate this
equipment. The input and output voltages used
with this equipment may be high enough to
endanger lif e, so
connectors must be fitted.
Please read this manual completely and convey
instructions to all
Keep the manual in a safe and convenient
place.
It is advisable to thoroughly read the
information on battery safety supplied with the
battery, prior to charging.
Towards the end of charge, lead acid batteries
give off hydrogen gas, which is explosive if
in sufficient concentration, therefore avoid
flames and sparks. Appropriate measures
must be taken to ensure adequate ventilation.
Incorrect use of a charger or maladjustment of
its controls can
The equipment has been factory set and does
not require user adjustment.
This product has been designed, manufactured
and certified to be in conformance with
European Safety and EMC Directives. Testing
has ensured that the battery and
combination conform as a system for use
in Light and Heavy Industrial environments
for each respective product variant. The
following notes are
the person installing and using the product.
The charger must be isolated from
input supply and the battery,
panels are removed.
Installation
Installation must only be carried out by suitably
qualified personnel and in accordance with
current local and national wiring regulations.
Battery leads should not be altered without prior
consultation with service personnel.
for the 2100 SP / OP Charger
insu la ted, shrouded
personnel concerned.
damage a battery.
charger
for the guidance
before any
The charger should be sited in a cool, dry, well-
ventilated location away from corrosive fumes
and humid atmospheres.
Care must be taken to ensure that the chargers
vents are not obstructed and have at least
100 mm of
Chargers must be positioned so that the
exhaust of one charger is not directly affecting
the inlet of another.
The charger is for inside use only.
Before installation, check that:
 The charger has not sustained any transit
damage.
The rating is suitable for the intended input

supply and 'lead acid' battery to be
charged.
The connector polarity is correct and

matches
connector.
Input supply
The input current rating and voltage of
charger is stated on the charger rating plate.
The rating of the protection device should be
based on the maximum input current, as stated
on this plate.
Display and Control
Overview
of
the
2
1. Tri-Colour Charge Status Indicator
2. Charger Voltage
3. Charger Current
4. Charger Profile
5. Pause Button
2
clearance from any
the polarity of the battery
3
4
GB
surface.
the
1
5