Tools Required - Heat Surge Roll-n-Glow Estate Manual Del Usuario

PORTRAIT fIREPLACE mOUNTING INSTRUCTIONS
WARNING:
Failure to install the Heat Surge Portrait fireplace as instructed below may result in damage to the unit, home or
personal injury.
WALL mOUNTING KIT INCLUDES:
• Wall plate
• 2 - 2½" Screws
• 2 - Wall Anchors

TOOLS REQUIRED:

• Drill and drill bit (Anchor 5/16" and 1/8" for #10 Screw)
• Screw driver (Phillips or Slotted)
• Pencil
• Stud finder
READ ALL INSTRUCTIONS bEfORE mOUNTING ThE hEATING UNIT.
1. Select an appropriate location to mount the Portrait Fireplace above an electrical outlet.
2. The wall plate must be mounted to at least one stud and anchored in another
location on the wall. To determine the location of the wall studs, use a stud
finder and mark the location of the studs with a pencil. To locate a stud without
a stud finder, tap or knock on the wall and listen for changes in tone. a hollow
sound is not a stud; a solid sound is a good indicator that you have found a
stud.
3. Using the wall plate with built-in level, mark two mounting locations to align
with the studs or on a location directly on the wall.
4. Drill holes as shown using appropriate drill bit.
5. insert screws or anchor in drilled holes to mount
wall plate to the wall.
6. with the help of another person hang
portrait fireplace against the wall as
shown. DO NOT ATTEmPT TO hANG
UNIT ALONE. TWO PEOPLE mUST bE
USED IN hANGING ThE PORTRAIT
fIREPLACE.
9