Heat Surge Roll-n-Glow Estate Manual Del Usuario página 6

fILTER INSTRUCTIONS
(optional product offering)
INSTALLING ThE fILTER SySTEm (some models)
The aYr filter system ships ready to install right out of the box. after removing
the filter frame from its packaging, shut down and unplug the fireplace to prepare
for installation. next, position the fireplace so that the back of the unit can be
easily accessed. Finally, position the filter so it will completely cover the upper
metal vents on the back of the fireplace and push the filter frame firmly against
the metal wall. The magnetic frame will snap into place. Verify the filter frame
has a good seal to the rear wall of the fireplace and reposition the fireplace for
normal operation.
nOTe: all filter systems require maintenance. Please see the Maintenance section of this manual to better understand
the maintenance required. Failure to follow the manufacturers' filter maintenance procedures could lead to damage of the
heating unit.
INSTALLING ThE ALLERGEN fILTER (optional product offering)
The white pleated allergen filter was designed as an option to offer a higher level of filtration by reducing common allergens. To
install the allergen filter in the aYr magnetic filter frame follow these instructions.
First, shut down and unplug the fireplace to prepare
for installation. next, position the fireplace so
that the back of the unit can be easily accessed.
next, remove the filter frame from the back of the
fireplace by firmly grabbing the magnetic frame and
separating it from the heating unit. Then, push the
standard blue filter out of the frame. The filter is
flexible and will come out easily. Finally, install the
white allergen filter into the frame by placing the
bottom and one side in first, then push the top and
second side in slowly, making sure the filter is not gapped and rests smoothly in the track on all four sides. now, verify the filter
frame has a good seal to the rear wall of the fireplace and reposition the fireplace for normal operation.
ADDING AmISh SCENTS TO ThE SCENT PAD
The aYr filter system comes equipped with a fragrance delivery system.
By placing optional amish scents on the scent pad, the fireplace can
deliver the desired aroma throughout the room. To enjoy the scents
of amish country follow these steps. First, shut down and unplug the
fireplace to prepare for installation. next, position the fireplace so that the
back of the unit can be easily accessed. Then, remove the scent frame
from the aYr filter frame by lifting the scent frame up to the horizontal
position and then push inward. You can remove the scent frame while
leaving the aYr filter frame in place. Finally, verify the scent pad is installed
correctly in the scent pad frame and place the amish fragrances directly
onto the scent pad. now, replace the scent frame back onto the aYr filter
frame and reposition the fireplace for normal operation. The amish fragrances will now pass through the fireplace and out
into the room during operation.
nOTe: Use only approved Heat Surge amish scents on the aYr filtration system. These scents have been tested and have
been found to be non-toxic and non-flammable.
5