Power Supply; Using Ac Power; Switching Power On/Off: Save Energy - Philips EXPANIUM AZ 1138 Manual De Usuario

XP AZ 1138/17 10-07-2001 18:42

Power Supply

Whenever convenient, use the power
supply if you want to conserve battery life.
Make sure you remove the plug from the
set and wall outlet before inserting
batteries.
Batteries (not included)
6 x 1.5V R14/ UM2/ C CELL
1 Open the battery compartment and insert
six batteries, type R-14, UM-2 or C-cells,
(preferably alkaline) with the correct
polarity as indicated by the "+" and "–"
symbols inside the compartment.
2 Close the compartment door, and make
sure the batteries are firmly and correctly in
place.The set is now ready to operate.
If BATT LOW lights up, battery power
is running low.The BATT LOW
indicator eventually goes out if the
batteries are too weak.
Batteries contain chemical substances,
so they should be disposed of properly.
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst.Therefore:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
Pagina 9
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.

Using AC Power

1 Check if the power voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local
power supply. If it does not, consult your
dealer or service center.
2 Connect the power cord to the AC MAINS
inlet and the wall outlet.The power supply
is now connected and ready for use.
3 To switch off completely, unplug the power
cord from the wall outlet.
• Unplug the power cord from the wall
outlet to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
Switching power on/off:
Save energy
Whether you are using mains or battery
supply, to avoid unnecessary energy
consumption always adjust the POWER
slider to TAPE/
cassette keys are released.
Power Supply
and check if the
OFF
9