Programming Track Numbers; Reviewing Your Program; Erasing A Program; Cassette Recorder - Philips EXPANIUM AZ 1138 Manual De Usuario

XP AZ 1138/17 10-07-2001 18:42
MP3-CD/ CD-Player

Programming track numbers

You may store up to 20 tracks in the
desired sequence. If you like, store any track
more than once.
1 In the STOP mode, press
TRACK•SEARCH ∞ , § or
TRACK +/–10 PRESET 3 or 4 for your
desired track.
2 When your chosen track number appears,
press CD MODE•PROGRAM once to
store the track.
The display shows
'P ro g' briefly followed by your selected
track number.
If you attempt to program without first
selecting a track number, no SEL is
shown.
3 Repeat steps 1 to 2 to select and store all
desired tracks in this way.
FULL is displayed if you attempt to
program more than 20 tracks.
4 To play your program, press
PLAY•PAUSE 2;.

Reviewing your program

• In the STOP mode, press and hold down
CD MODE•PROGRAM for more than
one second.
The display shows all your stored track
numbers in sequence.
14
Pagina 14
and
PROGRAM

Cassette recorder

Erasing a program

You can erase the contents of the memory
by any one of the following:
– opening the CD door;
– selecting RADIO or TAPE source;
– pressing STOP 9 (twice during playback
or in the stop position.)
Display: shows ' no P ro g' briefly when
the program is cancelled.

Cassette playback

1 Adjust the POWER slider to TAPE/
2 Press STOP•OPEN 9/ to open the
cassette door and insert a recorded
cassette.
3 Close the cassette door.
4 Press PLAY 1 to start playback.
Display: shows tAPE throughout tape
operation.
5 To pause playback press PAUSE ;.To
resume, press the key again.
6 By pressing 5 or 6, fast winding of the
tape is possible in both directions.To stop
fast winding, press STOP•OPEN 9/.
7 To stop the tape, press STOP•OPEN 9/.
• The keys are automatically released at the
end of the tape, the tAPE indication goes
out and the set is switched off, except if
PAUSE ; has been activated.
.
OFF