Publicidad
Idiomas disponibles
Idiomas disponibles
5.
How to Solder
File off any dirt, rust or paint on the parts you wish to solder.
Heat the parts with the soldering iron.
Apply resin-based solder to the part and melt it with the soldering iron.
Be sure to apply a solder paste to the part before applying non resin-based solder.
Wait for the solder to cool and harden before moving the soldered part.
Handle a heated soldering iron with extreme care as the high temperatures may cause
burns.
The soldering iron may produce smoke at first use due to a dried out heating element.
This is normal and should only last for approx. 10 minutes.
Never file the soldering tip.
Use a soldering iron stand in order to avoid burns.
The temperature of the soldering iron will drop if it is used without the tip.
Let the soldering iron cool after use.
The mains cable of this device should not be replaced. Discard the device if the power
cable has been damaged.
Cleaning and user maintenance shall not be made by children without supervision.
6.
Operation
1.
Install the solder reel onto the soldering gun. Press the fast-feeding button and
feed the soldering wire deep enough into the feeding hole until the wire protrudes
out of the extraction tube. Make sure the wire sits perfectly under the soldering tip.
2.
Connect the mains plug into an electrical outlet.
3.
Select the heating power (0 = off, I = 30 W, II = 60 W) and let the soldering iron
warm up.
4.
You can start soldering once the soldering iron up to temperature. Feed soldering
wire by pressing the feeding trigger.
5.
Switch off and disconnect the appliance after use.
Do not apply the soldering iron to the same place for a long time.
Do not leave the device unattended when switched on.
V. 01 – 28/02/2018
VTSG60SFN
5
©Velleman nv
Publicidad
