Adjusting To The Carriage Position; To Attach The Via Infant Car Seat; To Remove The Via Infant Car Seat - The First Years Burst S530 Manual De Instrucciones

Section 5 - Operation and Use - continued

7. Adjusting to the carriage position:

A. Recline the seat back to the bottom position.
Rotate legrest pad up to close off area under
the child's tray.
B. Rotate flaps out to prepare for attaching to
child's tray.
C. Rotate flap over child tray and attach U-clip
to underside of tray.
D. Insert bottom velcro strap through
1
slot in seat side . Rotate strap back on
2
itself and attach firmly .
E. Take top strap with U-clip and clip onto
tube as shown.
Note: Always check to ensure clips and
attachments are secure.
11

8. To attach the Via infant car seat:

A. Recline the seat back to the most reclined
position and lock the rear wheel brakes.
B. Remove the armrest covers by pulling down
and then flip over armrest cover to inside of
seat.
C. Lower the Via infant car seat into the armrests
until it clicks.
Note: Pull up on infant seat to ensure it is
attached.
1

9. To remove the Via infant car seat:

A. Pull release handle on back of infant car seat
Pull up on infant car seat
2
detach from hinges. Reattach armrest covers.
Section 5 - Operation and Use - continued
2
to remove and
2
1
.
1
12