Baby Jogger city GO i-Size Manual De Instalación página 16

EN
16 Press the red button on the buckle to unfasten the
buckle. Place harness straps off to the sides.
17 Place Your Child in the Seat
Make sure their back is flat against the car seat back.
18 Place Harness Straps Over Child' s Shoulders
19 Be Sure the Harness Straps are at the Proper Height
Harness straps must be at or just below the child' s
shoulders.
20 The top of child' s head must be at least 2.5 cm (1")
below the top of the headrest.
21 To change harness height, from the back of the seat,
squeeze the headrest adjustment buttons and move it
up or down to the correct harness position.
22 Buckle Harness Straps
Fit the two buckle tongues together and push them
into the buckle. You will hear a "click" when buckle
tongues are securely attached. Pull up on the buckle
tongue to make sure it is securely attached.
23 Pull All the Slack Out From around the Waist
Pull up on the harness strap while pushing the buckle
tongue down. Do this on both sides.
24 Tighten the Harness by Pulling the Harness
Adjustment Strap
When you are not able to pinch any of the harness
webbing at your child' s shoulder, the harness is tight
enough.
UNSAFE VEHICLE SEAT LOCATIONS
Never install this car seat in any of the following vehicle
seating locations:
25 rear-facing or side-facing vehicle seats
26 rear-facing with an active front air bag
16