Setup Wizard - Intellinet Network Solutions 524780 Guía De Montaje Rápido

Wireless ADSL2+ Modem Router • Quick Install Guide
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS
Modem Router.
This guide presents the basic steps to set up and operate this device. For detailed
instructions and specifications, refer to the user manual on the CD enclosed with this
product or at www.intellinet-network.com.
Package Contents
• Wireless ADSL2+ Modem Router
• Power adapter
• Ethernet Cat5 RJ45 cable, 1.0 m (3 ft.)
• RJ11 telephone cable, 1.8 m (5.9 ft.)
• Setup CD with user manual and setup wizard
• Quick installation guide
HARDWARE SETUP / CONNECTIONS
1. Connect the router to your ADSL cable using the supplied RJ11 cable.
2. Connect the router to your PC, hub or switch by attaching the Ethernet cable to the
LAN port of the router.
3. Connect the power adapter to the power jack on the rear panel of the router.
4. The ADSL LED will be on if the router is connected to the ADSL cable and receives
the ADSL signals successfully. If the LED is blinking, contact your ISP (Internet
service provider) to check the problem.
NOTE: Use only the power adapter included with the router.

SETUP WIZARD

This router provides a Setup Wizard for configuring the ADSL settings. This wizard
collects ADSL settings from some ISPs so that you can easily configure the router's
ADSL settings just by selecting the ISP vendor from the wizard. If you can't find your
ISP from the list in the wizard, manually set the ISP information. Both procedures are
presented below.
Getting Started
Before starting, check the following items:
• Make sure you've connected the ADSL cable to the router correctly. (The ADSL LED
will be on.)
• Un-install any dial-up programs installed previously for the USB modem or other
dial-up devices.
• It's recommended that you initially configure the router through the Ethernet cable
before you set the wireless functions.
2
ENGLISH
English
Wireless ADSL2+
™