Intellinet Network Solutions 524780 Guía De Montaje Rápido página 5

2. Check with your ISP as to the connection type of the ADSL line. Select the
Connection Type (below) and click "Next. "
3. Input the VPI, VCI and encapsulation data supplied by your ISP. If the Connection
Type is "Static IP Address, " input the IP address information supplied by your ISP.
For details about each setting, refer to Web Management Configuration / General
Setup in the user manual.
4. Enter the username and password that your ISP provided, if needed. Click "Next. "
5. Confirm the information that appears on the Settings Overview screen is correct,
then click "Save" to save the settings and reboot the router. NOTE: Click "Back" to
change settings on a previous screen.
6. After saving and rebooting the router, the ISP settings are done. The wizard will
then help to set your computer to obtain an IP address from the router automatically.
A screen with a status bar will display to indicate the progress of the procedure.
NOTE 1: To use the router to access the Internet, the IP address of each PC needs to
be set in the same network segment as the router. The wizard will help to set the
proper IP address for your computer.
NOTE 2: By default, the router's DHCP server is enabled. If it's disabled before
running the wizard, the wizard will enable the DHCP server automatically.
7. The wizard will attempt to connect to the selected ISP. If the attempt fails, a screen
prompt will indicate this is the case. Run the wizard to select the ISP again.
8. If you do successfully connect to the ISP, you'll see a confirmation screen. To
configure additional Web management settings, click "Advanced Settings. " To close
the wizard, click "Finish. "
5
ENGLISH