Manuales relacionados para Husqvarna YTH2754T
Resumen de contenidos para Husqvarna YTH2754T
- Página 1 07002 YTH2754T Operator's Manual "This machine is approved by the EPA for E10 (10% ethanol) and lower fuel only. Do not use any fuel >E10 in this machine." 12.11.10 BAD 532 43 93-24 Printed in the U.S.A...
-
Página 2: General Operation
SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, discharge chute, or other safety devices in place and WARNING: In order to prevent ac- ci den tal starting when setting up,... - Página 3 SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to •...
-
Página 4: Tabla De Contenido
PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 4 Gallons and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 10W30 (above 32°F) SAE 5W-30 (below 32°F) •... - Página 5 UNASSEMBLED PARTS Mower Mower Front Wheel (2) Rear Lift Link (1) Shoulder Bolt Assemblies (1) 1-1/4 O.D. Washer (1) Small Retainer Springs (1) Front Lift Link (1) 3/8-16 Assembly (1) Wheel Locknut (5) Large Retainer Springs Slope Sheet (1) Oil Drain Tube If Equipped Keys (1) 3/4 O.D.
-
Página 6: Tools Required For Assembly
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. - Página 7 ASSEMBLY 4. SLIDE MOWER UNDER TRACTOR (See Fig. 8) • Bring belt forward and check belt for proper routing in LIFT all mower pulley grooves. LEVER NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor. •...
- Página 8 ASSEMBLY 7. ATTACH REAR LIFT LINKS (C) (See Fig. 13) • Insert rod end of rear lift link (C) into hole (U) in tractor lift ANTI-SWAY BAR TRANSAXLE (S) LOCATION BRACKET (T) shaft suspension arm and pivot link down to mower. LOCATED •...
- Página 9 ASSEMBLY ✓CHECKLIST 9 INSTALL BELT ON ENGINE CLUTCH PULLEY (M) (See Fig. 7 & 15) BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE • Disengage belt tension rod (K) from locking bracket (L). WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- •...
-
Página 10: Operation
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. FAST SLOW REVERSE HIGH NEUTRAL CHOKE IGNITION SWITCH ENGINE START MOWER HEIGHT MOWER LIFT REVERSE ENGINE ON PARKING BRAKE ENGINE OFF OPERATION SYSTEM (ROS) CLUTCH/BRAKE... -
Página 11: Know Your Tractor
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. Fig. - Página 12 OPERATION THE OPERATION OF ANY TRACTOR CAN RESULT IN FOREIGN OBJECTS THROWN INTO THE EYES, WHICH CAN RESULT IN SEVERE EYE DAM AGE. ALWAYS WEAR SAFETY GLASS ES OR EYE SHIELDS WHILE OPERATING YOUR TRACTOR OR PER FORM ING ANY ADJUSTMENTS OR REPAIRS. WE REC OM MEND A WIDE VISION SAFETY MASK OVER SPECTACLES OR STAN DARD SAFETY GLASSES.
- Página 13 OPERATION • The average lawn should be cut to approximately TO MOVE FORWARD AND BACKWARD 2-1/2" during the cool season and to over 3" during hot (See Fig. 20) months. For healthier and better looking lawns, mow The direction and speed of movement is controlled by the often and after moderate growth.
-
Página 14: To Stop Mower Blades
OPERATION TO STOP MOWER BLADES TO OPERATE ON HILLS • Disengage at tach ment clutch con trol. CAUTION: Do not drive up or down hills with slopes greater than 15° and do not CAUTION: Do not operate the mower drive across any slope. without either the en tire grass catcher, on mowers so equipped, or the deflector shield •... - Página 15 OPERATION TO START ENGINE (See Fig. 16) SERVICE REMINDER/HOUR METER When starting the engine for the first time or if the engine Service reminder shows the total number of hours the engine has run out of fuel, it will take extra cranking time to move has run and flashes to indicate that the engine or mower fuel from the tank to the engine.
-
Página 16: Mowing Tips
OPERATION PURGE TRANSMISSION MOWING TIPS • Tire chains cannot be used when the mower hous ing CAUTION: Never engage or disengage is attached to tractor. freewheel lever while the engine is run ning. • Mower should be properly leveled for best mowing performance. -
Página 17: Maintenance Schedule
MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH SEASON STORAGE SCHEDULE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure Check Operator Presence & ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness... -
Página 18: Maintenance
MAINTENANCE TRACTOR BLADE CARE For best results mower blades must be kept sharp. Re place Always observe safety rules when per form ing any bent or damaged blades. main te nance. CAUTION: Use only a replacement blade ap- BRAKE OPERATION proved by the manufacturer of your tractor. -
Página 19: Engine Lubrication
MAINTENANCE V-BELTS OIL DRAIN VALVE Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not CLOSED ad just able. Re place belts if they begin to slip from wear. LOCKED POSITION TRANSAXLE COOLING The transmission fan and cooling fins should be kept clean DRAIN... - Página 20 MAINTENANCE IN-LINE FUEL FILTER (See Fig. 31) 1. Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach. The fuel filter should be replaced once each season. If fuel IMPORTANT: Make certain the tractor’s discharge chute is filter becomes clogged, ob struct ing fuel flow to car bu re tor, directed AWAY from your house, garage, parked cars, etc.
-
Página 21: Service And Adjustments
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. •... - Página 22 SERVICE AND ADJUSTMENTS TO LEVEL MOWER • If adjustment is necessary, see steps in Visual Adjust- ment instructions above. Make sure tires are properly inflated to the PSI shown on • Recheck measurements, adjust if necessary until both tires. If tires are over or under inflated, it may affect the sides are equal.
- Página 23 SERVICE AND ADJUSTMENTS TO REPLACE MOTION DRIVE BELT (See Fig. 40) Park the tractor on level surface. En gage parking brake. For as sis tance, there is a belt installation guide decal on bottom side of left footrest. BELT REMOVAL - •...
- Página 24 SERVICE AND ADJUSTMENTS FRONT WHEEL TOE-IN/CAM BER TO START ENGINE WITH A WEAK BATTERY (See Fig. 42) Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the WARNING: Lead-acid batteries gen- factory set front wheel toe-in or camber, contact a qualified er ate ex plo sive gases.
- Página 25 SERVICE AND ADJUSTMENTS REPLACING BATTERY (See Fig. 43) TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 44) WARNING: Do not short battery ter mi- • Raise hood. nals by allowing a wrench or any other • Unsnap headlight wire connector. object to contact both terminals at the •...
-
Página 26: Storage
STORAGE Immediately prepare your tractor for storage at the end ENGINE of the season or if the tractor will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS WARNING: Never store the trac tor with FROM FORMING IN ES SEN TIAL FUEL SYSTEM PARTS SUCH gas o line in the tank inside a building AS CARBURETOR, FUEL FIL TER, FUEL HOSE, OR TANK... -
Página 27: Trou Ble Shoot Ing
TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4. - Página 28 TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine dies when 1. Reverse operation system 1. Turn ignition key to tractor is shifted (ROS) is not "ON" while ROS "ON" position. into reverse mower or other attachment See Operation section. is engaged. Engine continues to 1.
-
Página 30: Warranty
(e.g., engines and transmissions) are excluded from coverage, and other limitations apply, as described in this document. Husqvarna will repair or replace at its discretion, any defective product or part covered by the Limited Warranty, free of charge at any authorized Husqvarna Servicing Dealer/Center using original OEM Husqvarna replacement parts, subject to the limitations and exclusions described below. - Página 31 Husqvarna unit to an authorized Husqvarna Servicing Dealer/Center and arrange for pick-up or return of your unit after the repairs have been made. If you do not know the location of your nearest authorized Husqvarna Servicing Dealer, call Husqvarna, at 1-800-487-5951 during the hours of 8:00 AM to 8:00 PM Eastern Standard Time, or visit www.husqvarna.com.
- Página 32 ** See reference 1 (b) of the warranty statement. RZ - Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear Distributor network. EZ - One (1) Year Commercial warranty, parts & labor, with Husqvarna. Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear Distributor network.
- Página 33 ** See reference 1 (b) of the warranty statement. RZ - Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear Distributor network. EZ - One (1) Year Commercial warranty, parts & labor, with Husqvarna. Two (2) Year Consumer warranty, parts & labor, with Hydro-Gear Distributor network.
- Página 34 12.11.10 BAD Printed in the U.S.A.