Advanced Operation - Xtech XTH-700 Guía De Usuario

- Voice quality when speaking will be best when there are no obstacles
between the mobile phone and earphones, including your body.
V. Advanced operation
5.1. Pairing your earphones with a mobile device
1. Turn both earphones on by removing them from the charging case or by
pressing the Multifunction button for 4 seconds on both sides
simultaneously.
2. Set your Bluetooth phone to "discover" the wireless earphone.
®
3. Place the phone and earphones within one meter of each other.
4. Left and right earbuds should pair together automatically. After both
earphones synchronize with each other, the blue LED will blink slowly in one
of them, while the red and blue LEDs will start alternating quickly in the
second earphone to indicate that it has entered into the pairing mode.
5. Select the XTH-700 earphone from the list of newly discovered devices in
your phone.
6. Accept by pressing Yes or OK on the device. If prompted, enter the passkey
0000 (4 zeros). Your device will confirm when pairing is complete.
7. The Your device is connected prompt will be heard when the mobile phone
and earphones are able to establish the wireless connection, making the LED
change to blinking blue.
8. If after 60 seconds the pairing process fails, please repeat steps 1 through 6
as described above.
9. The earphones will automatically go into standby mode after a short period
of inactivity to save battery life.
10. You only need to pair the earphones with your phone once, as it will re-pair
automatically.
11. The automatic re-pairing feature will allow the headset to be reconnected
after being switched back on or when placed again within wireless range.
5.2. Call management using your wireless earphones
• When there is an incoming call, your phone will ring, the blue LED will blink
once every 5 seconds, accompanied by a tone through the earphones.