Publicidad
GB
INSTRUCTIONS FOR USE
Non contact voltage indicator with audible warning and self-test feature. For
conductors energised at voltages in the range of 100V to 600V AC.
Hold the voltage sensing device in the palm of the hand. The user is part of the
response circuit. Slide the switch across to the middle 'TEST' position with the
thumb and check that both green and red indicators are on and that the audible
tone is present. Slide the switch to the far right 'ON' position and check that the
green indicator in on. The sensing device is now ready for use. The red indicator
and audible tone will indicate and sound simultaneously when the nose of the
sensing device is placed in the proximity of a live conductor.
TECHNICAL SPECIFICATION
Battery: 9v alkaline battery, MN1604 or equivalent (not included).
Voltage Range: 100V to 600V AC.
Voltage Sensitivity: See table below.
Frequency Range: 50Hz to 50kHz.
Indicators: LED (red) and audible tone (3kHz) - voltage present. LED (green) -
battery ok.
Operating Temperature Range: -5 to 40°C.
Case Details: Yellow ABS.
Dimensions: 202 x 32 x 22mm.
Weight: 140g (excluding battery).
TYPICAL SENSING DISTANCE OF ENERGISED CABLE
Cable Type:
Flat 1mm
2
Twin & Earth:
2.5mm
2
Twin & Earth:
Round 1.5mm
2
:
WARNING
The sensing device must be tested before and after use to ensure full
functionality. DO NOT USE THE TESTING DEVICE IF THE RED, GREEN AND
AUDIBLE TONE INDICATORS ARE NOT SIMULTANEOUSLY ACTIVATED IN
THE TEST POSITION. From some directions the neutral and earth conductors
in cables will shield the live, so it's important that a cable is explored from all
directions. This unit is a non contact device and is not to be put in contact
with hazardous conductive surfaces. When testing for the presence of
voltage in multi-core cables always run the sensing device along a short
length of cable so as to overcome the natural twist in conductors.
Replace battery if the green light fails to illuminate.
2
110V AC 50Hz
240V AC 50Hz
3mm
23mm
5mm
23mm
2mm
18mm
7
Publicidad
