Publicidad
Step 8
1
D30
Groove
å
Insert the DRAWER SIDES (D30 and D31) at an angle
into the slot at each end of the DRAWER FRONT (J2).
3
Minimum
190 degrees
M67
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M67) to the
DRAWER FRONT (J2). Tighten one HIDDEN CAM.
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D31
J2
Maximum
Arrow
210 degrees
J2
VIEW THE T-LOCK BOX VIDEO
2
U n fi
n i s h
s u r
e d
f a c
e
D30
J2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D982) into the
grooves in the DRAWER SIDES (D30 and D31)
and DRAWER FRONT (J2).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D30
M67
å
Fasten the DRAWER BACK (D175) to the DRAWER
SIDES (D30 and D31) and DRAWER BRACE (M67).
Use five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the other DRAWER.
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D982
D31
30S
(10 used in this step)
D175
Be sure the
D31
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 13
Publicidad
