Fan Speed; Humidity Control - Essick Air ED11 Serie Manual De Cuidados Y Uso Del Propietario

Note: Place the unit at least FOUR inches away from any walls. Unrestricted airflow
into the unit will result in the best efficiency and performance.
1. Plug cord into wall receptacle. Your humidifier is now ready for use.

FAN SPEED

2.
Press the power button and select fan speed: F1 through F9 proceeding from low
to high speed.
NOTE: When excessive condensation exists, a lower speed setting is recommended.

HUMIDITY CONTROL

NOTE: Both models have an automatic humidistat that cycles the humidifier on and
off as required to maintain the selected setting.
3. At initial startup the relative humidity of the room will be displayed.
4. Each successive push of the Humidity Control Button will increase the setting in
5% increments. At 65% set point, the unit will operate continuously.
5. The control will display a flashing "F" when the water reservoir is empty. When
the unit is completely out of water, the motor will shut off.
6. This humidifier has a check filter reminder timed to appear after 720 hours of
operation. When the Check Filter (CF) message is displayed, disconnect the
power cord and check the condition of the filter. The CF function is reset after
plugging the unit back in.
OPTIONAL AIRCARE® FILTER
The first stage of the air filter is a high-efficiency, electrostatically-charged filter
media which traps dust, pollen, and airborne pollutants. The second stage is an
activated carbon media which absorbs odors from cooking, pets, or tobacco smoke.
We recommend replacing the AirCare® filter at least once a year and more often if
necessary. When the white filter media is coated with a layer of dust and dirt, it is
time to replace the AirCare® filter. The certified water output of your humidifier will
be reduced when using the AirCare® filter. AirCare® filters are optional and are not
required for normal operation of the humidifier. AirCare® is registered trademark of
Essick Air Products.
6