Quick Reference Guide; Compact Stove Installation - HOMEDEPOT ES2033 Manual Del Propietário

Quick Reference guide

①
Prior to the first use of
the Compact Stove verify the
following:
• Are the circuit breakers for the
unit on?
• Are the light bulbs in your
Compact Stove loose? (to
check, follow the instructions
for replacing the light bulbs
under the Maintenance section
of this manual)

Compact Stove Installation

!
NOTE: a 15 amp, 120
volt circuit is required. a
dedicated circuit is preferred
but not essential in all cases.
a dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuses blow on a regular basis
when the heater is operating.
additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
WARNINg: Ensure the
power cord is not installed so
that it is pinched or against a
6
②
the heater on your Compact
Stove may emit a slight, harmless
odor when first used. This odor is
a normal condition caused by the
initial heating of internal heater
parts and will not occur again.
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Construction and electrical
wiring must comply with local
building codes and other
applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
Do not attempt to wire your
own new outlets or circuits. to
reduce the risk of fire, electric
shock or injury to persons,