Publicidad
Idiomas disponibles
Idiomas disponibles
COLORado™ Batten Quad-9 Tour QRG
Power Linking
AC Plug
Replacing the
Fuse
DMX Linking
DMX Connection
Master/Slave
Connection
You can link up to 9 COLORado™ Batten Quad-9 Tour products at 120 V or
15 at 230 V. Never exceed this number. Power linking cords can be purchased
separately.
Connection
AC Live
AC Neutral
AC Ground
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The COLORado™ Batten Quad-9 Tour will work with a DMX controller using
a regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The COLORado™ Batten Quad-9 Tour uses a regular DMX data connection
for its DMX personalities: TOUR, TR16, ARC.1, AR1.D, ARC.2, AR2.D,
AR2.S, HALO, PIX1, PIX2, and HSV. See the User Manual to connect and
configure for DMX operation.
For optimum control of the 16-bit dimming channels in the TR16 personality,
be sure that both dimming curves in SET > DIMX and SET > CURV are set to
OFF.
The COLORado™ Batten Quad-9 Tour uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
3
Screw Color
Brown
Yellow/Brass
Blue
Green
EN
Silver
Publicidad
